Digital Audio Status - Decode Mode - Hitachi C32WF535N User Manual

problem identification
1. No digital audio. Pressing
the info/recall button on your
handset doesn't show Digital
audio modes or format in top
right hand corner of screen.
2. Digital audio works but
only PCM mode is available
even when playing a Dolby
Digital encoded disc.
3. No sound even at maximum
volume, although the correct
picture can be seen.
46
possible cause
No or poor digital connection
between television and external
equipment
Incorrect Decode Mode
Laserdisc with Dolby Digital RF
signal cannot be detected
Decode Mode is set for wrong
AV (you will have the correct
picture from your external
equipment but no sound)
Television is set to the wrong AV
(you will have the wrong picture
or no picture at all)
Player is not playing because it
has been switched off or placed
in 'Pause' mode.
Invalid or damaged disc has
been placed in player.
Signal options not supported by
television.
Digital audio out has not been
enabled on player.
Your external equipment has not
been configured to output a
digital bitstream, does not
support Dolby Digital output, or
the correct format is not enabled
on the external equipment.
You have not selected a Dolby
Digital track from the DVD title
menu
Headphones have been inserted
into front control panel.
External/internal speaker switch
is in the incorrect position.
remedy
See 'DVD, CD and LaserDisc
player connection'
Set the Decode Mode to
correct AV (see Decode
Mode set up procedure)
Fit adaptor as described in
'DVD, CD and LaserDisc
player connection'
Set the Decode Mode to
Digital or Auto (see 'Digital
Audio Status - Decode
Mode' set up procedure)
Use the Manual Setup
procedure to set the AV
correctly, or use the AV key
to cycle through the Audio
Visual options.
Refer to external equipment's
instructions
Refer to external equipment
instructions. Is the disc
compatible with the external
equipment you are using?
See Digital Audio Status for list
of modes available.
Refer to external equipment
instructions on how to enable
the digital audio output.
Refer to external equipment
instructions for compatibility.
Refer to title menu on disc to
set audio format
Remove headphones.
Place in correct position to use
appropriate speakers.