Table of Contents
Advertisement
SIGNAL QUALITY - If poor or noisy signals are experienced from your TV during normal opera-
tion, fit the supplied Relay RF cable between your VCR and TV. This measure will improve the
picture quality on your TV.
To automatically tune this TV to your local broadcasting stations follow the step by step guide below.
Once the TV has found all your local stations, then they are automatically assigned into the following
order:
1.BBC1; 2: BBC2; 3: ITV; 4:CH4/S4C; 5: CH5 (subject to availability); 6: Satellite.
Alternatively, if you are familiar with local broadcasting frequency or CH numbers, then these can be
entered manually. Please refer to the Manual Tuning Procedure section of this booklet.
IMPORTANT NOTE: If you have a VCR or a Satellite receiver connected to this TV please ensure
that they are switched on before Autotune commences. In the case of a VCR, insert a pre-
recorded tape and begin playback of your equipment. With a Satellite receiver, select SKY NEWS.
These measures ensure that all your equipment is tuned in during the AUTOTUNE procedure.
(Satellite equipment installation is explained in the 'Connecting of External AV Equipment sec-
tion').
Note: The VCR programme number should always be set to 0
Press and HOLD the MENU button until
1
Main Menu with INSTALL is shown
Highlight INSTALL using the up/down
2
(if INSTALL is not shown follow step
above once more).
Press the left/right buttons select
3
INSTALL. The INSTALL menu is
If language setting is incorrect, use
4
up/down buttons to highlight
LANGUAGE, and select using the
left/right buttons.
Use the up/down buttons to highlight
5
AUTOTUNE.
6
Use the left/right buttons to begin
AUTOTUNE.
buttons
shown.
Automatic Tuning Procedure
Automatic Tuning Procedure
Completed Autotune example.
7
7
Advertisement
Table of Contents
