Table of Contents
Advertisement
Before installing your TV please read the following important notes:
If you intend placing this TV into a cabinet or a wall alcove, please ensure there is at least a 100mm (10cm) gap to the
sides, rear and top of the Television. This is to allow for adequate ventilation during TV operation.
Don't allow soft furnishings such as curtains to be draped over the TV whilst in operation.
Never place the TV on to a carpet during normal operation - this could obstruct ventilation slots on the base of the TV.
Always place the TV on a flat surface , or if supplied, the stand accessory.
Failure to observe the above guidelines could result in serious overheating of your TV, or in extreme cases, even fire.
Connecting your TV to the mains socket.
(Please read the Safety Notes in the 'TV Safety
Section' with reference to unattended operation).
TV only installation.
Aerial (RF) Lead
Installation via a VCR.
Aerial (RF) Socket TV
(RF) connecter lead VCR to TV
Aerial (RF) Lead
*A scart lead should be fitted between your TV and VCR to enhance your picture and sound quality. Scart leads are
essential if you have a stereo TV and VCR and wish to obtain stereo sound from your equipment. These leads can
be purchased from your Hitachi dealer or any good 'High Street' electrical retailer.
Insert Plug and
Switch on
Aerial (RF) Socket
OUT
Aerial (RF) Socket VCR
5
5
TV Installation
TV Installation
L
R
2 x 12W 8
L
R
2 x 12W 8
*Optional Scart Lead:
TV to VCR
Advertisement
Table of Contents
