Mounting The Reel Stand - Duerkopp Adler 550-767 Installation Instructions Manual

2.5 Mounting the reel stand

3 1 2 1
The structure and position of the reel stand 3 can be seen in the
illustration.
–
Fit reel stand 3 in the hole of the table plate and secure it with
nuts 1 and washers 2 supplied.
–
Fit the reel holders and take-up arms. The reel holder and take-up
arm of each reel must be vertically in line.
–
If necessary adjust retaining pins 4 to the height of the
needle-thread cone.
Once the attachment 5 has been secured, the needle-thread cone
must press on the switch 6.
4 5
6
4
2
5