Control Unit And Operating Panel; General - Duerkopp Adler 467 Operating Instructions Manual

6. Control unit and operating panel

6.1 General

The operating panel is used to program the control unit and to set the seam functions.
Depending on the nature of the job, sewing may be executed manually or by seam
programming.
For differing jobs seams can be programmed for which the functions (starting bar tack,
ending bar tack, stitch count, thread cutting etc.) and parameter values (stitch rate,
seam length, rpm etc.) are individually assigned.
Entry is carried out in programming mode.
The parameters and the values assigned are displayed.
The seam programs are not lost even when the sewing machine is switched off (battery
buffer).
In order to avoid the inadvertent alteration of pre-set functions, operation is divided into
various levels (operator, technician, fitter).
The operator (seamstress) can program directly.
On the other levels access is contingent on the entry of a code number (EFKA).
RESET
If the control unit is hopelessly misadjusted, this function allows the technician to reset
all adjusted values to their default (ex-works) settings.
This function is described in the Servicing instructions.
IMPORTANT
This operating manual covers only the key functions and
change of parameters by the operator.
For a detailed description of the control unit please see the
motor manufacturer's current operating manual (attached).
17