Follow the instructions given on the screen to perform the upgrade. When the
upgrade is complete the program will confirm that the upgrade has been successful
and then quit.
Step 7 - Switch the UPGRADE key to the OFF position and cycle the power
Switch the UPGRADE switch on the rear of the LINDY Dual/Quad PRO to the OFF
position and disconnect the power. When the power is re-applied the LINDY
Dual/Quad PRO will operate using the new firmware.
Some useful issues to bear in mind when performing flash upgrades
The upgrade program rewrites the LINDY Dual/Quad PRO's firmware code. If the
upgrade process is interrupted then the LINDY Dual/Quad PRO will have invalid
code and will not be able to operate. It is therefore good practice to ensure that the
upgrade process is always fully completed. A partial or failed upgrade may be
rectified by performing another upgrade. If the upgrade process is interrupted
accidentally then you should immediately repeat the upgrade process without
moving switch 2 from the upgrade (ON) position. Switch 2 forces the LINDY
Dual/Quad PRO into flash upgrade mode and prevents the upgraded code from
being run. Running faulty or partially upgraded code may have unpredictable results
and may damage your LINDY Dual/Quad PRO or computing equipment. For obvious
reasons, the code that the LINDY Dual/Quad PRO uses to perform upgrades is not
itself upgradable - a common problem on some flash upgradable products that could
effectively be destroyed by a partial upgrade!
WARNING - Running faulty or partially upgraded code may have unpredictable
results and may damage your LINDY Dual/Quad PRO or computing equipment.
LINDY Dual/Quad PRO
Installation and Use
Page 64