Adjusting The Tuner Calibration; Restoring The Factory Preset Programs; Troubleshooting - ToneWorks AX3G Owner's Manual

Note name C C# D
Display
3. If your guitar is sharp (pitch too high), the Program Up switch LED
will blink. If your guitar is flat (pitch too low), the Program Down switch
LED will blink. In either case, more rapid blinking indicates that your
guitar is farther from the correct pitch.
When in tune, both the Program Up and Down LEDs will light.

Adjusting the tuner calibration

When you turn on the power, the built-in tuner is set to a reference pitch
of A 440 Hz (concert pitch). You can calibrate this reference pitch in a
range of 438 Hz–445 Hz. You can use the [ ]/[ ] buttons to calibrate
this in the range of 438 Hz–445 Hz. When doing so, the program/value
display will indicate a value of 38–45.
When you turn off the power, the calibration adjustment you made will
be discarded and the AX3G will automatically be set to 440 Hz.

Restoring the factory preset programs

Here's how to restore (reload) the AX3G's programs back to factory pre-
set programs.
When you execute this operation, all the programs you created and stored
inside the AX3G will be erased, and replaced by the factory programs.
1. While holding down both the Program Up and Down switches as
well as the [ (CANCEL)] button, turn on the power. The program/
value display will indicate "
the Program Up/Down switches will blink. Take your hand off both
switches and the button you had been pressing.
10
D# E F F# G G# A
", and the LEDs in the upper part of
2. If you decide to cancel the reload operation at this point, press the
A# B
[CANCEL] button.
3. If you wish to reload the factory settings press the [ (WRITE)] but-
ton. The program/value display will indicate "
begin. When reloading is completed, the program/value display will
indicate " ", and the AX3G will automatically enter Program mode.
Never turn off the power while reloading.
If you suspect a malfunction, please check the following points. If this
does not resolve the problem, please contact a nearby dealer.
1. Power does not turn on
Have the batteries have run down? When the batteries run low,
the display will blink "
batteries as soon as possible. If batteries become unusable, re-
move them immediately. Leaving drained batteries in the unit can
cause malfunctions (such as battery leakage). You should also
remove the batteries if you won't be using the AX3G for an ex-
tended time.
Have you have inserted a stereo cable into the INPUT jack?
When operating the AX3G on batteries, the power will not turn
on if you insert a stereo cable. Be sure to use a mono cable.
Is the AC adaptor connected to the rear panel DC9V jack?
Is the AC adaptor plugged into an AC outlet?
Could the AC adaptor be damaged?
2. No sound
Is the volume of your guitar turned down?
Is your guitar cable connected correctly?
Is your guitar cable broken?

Troubleshooting

". We recommend that you replace the
" and reloading will