Advertisement
EasyStart
A
m
p
A
m
p
G
u
i
t
a
G
u
i
t
a
M
a
i
n
F
M
a
i
n
F
REMS technology delivers an
array of classic Guitar/Bass
Amp, Speaker Cabinet and
Effect models
Intuitive user interface with 3
Select Dials and 6 Knobs
Loaded with 11 classic and
modern Guitar & Bass
Amplifiers
11 sought after Cabinet models
for Guitar and 10 Cabinet
models for Bass
9 Guitar Effect models
(Ampworks), 11 Bass Effect
models (Ampworks bass)
11 Preset Amp settings, 2 User
Programmable settings, plus
Manual setting
Battery or AC powered
A
u
d
i
o
C
o
n
n
e
c
t
i
A
u
d
i
o
C
o
n
n
e
c
t
i
1.
If connecting headphones or powered monitors, select "LINE" on the LINE/AMP switch on the rear panel.
Select "AMP" if connecting to a guitar amplifier.
2.
After making audio and AC connections, connect your guitar to the INPUT jack on the back panel. If using
headphones, connect to the OUTPUT jack on the back panel. On the top panel, lower the VOLUME level and
turn on the power by plugging the optional DC 4.5V adaptor into an AC outlet. The POWER LED will light and
the power will turn on.
3.
If using batteries, the power will turn on when a mono cable is plugged into the INPUT jack.
4.
Connect the OUTPUT jack to your mixer or guitar/bass amp.
5.
When connections are complete, turn on the power of the mixer or amp and adjust the volume
appropriately.
w
o
r
k
s
w
o
r
k
s
r
/
B
a
s
s
r
/
B
a
s
s
e
a
t
u
r
e
s
e
a
t
u
r
e
s
o
n
s
:
o
n
s
:
Advertisement
Table of Contents
Related Manuals for ToneWorks Ampworks
Summary of Contents for ToneWorks Ampworks
- Page 1 Amplifiers 11 sought after Cabinet models for Guitar and 10 Cabinet models for Bass 9 Guitar Effect models (Ampworks), 11 Bass Effect models (Ampworks bass) 11 Preset Amp settings, 2 User Programmable settings, plus Manual setting Battery or AC powered If connecting headphones or powered monitors, select “LINE”...
- Page 2 NOTE: Restoring the factory settings will over-write any changes you have made in PROG1/PROG2. By bypassing Ampworks, your sound will be direct (dry) so there will be no amp types, cabinets, or effects. When bypassed, the PRESET or PROG/MANU LED will be off.
- Page 3 This means that if Flanger is selected (which has a proportion to tap interval of x2,) if you tap at a 4 second interval, Ampworks will set the parameter value (flanger speed) to twice that length, or 8 seconds. You can also adjust the amount of effect level by turning the “Eff. depth” control.
Need help?
Do you have a question about the Ampworks and is the answer not in the manual?
Questions and answers