Selecting A Program; Creating Your Sound (Edit Mode); Signal Flow; Selecting Effects And Adjusting The Main Parameters - ToneWorks AX3G Owner's Manual

Down switch or Program Up switch, letting you change instantly between
sounds.
To enter Program mode, set the function selector to [PROGRAM]. (The
LEDs in the upper part of the Program Up/Down switches will light.)

Selecting a program

1. Make sure that the function selector is set to [PROGRAM].
Make sure that the function selector is set to [PROGRAM].
In Program mode, the LEDs of both the Program Up and Program
Down switches will be lit.
When you turn on the power, you'll be in Program mode regardless
of the position of the function selector.
2. Turn the value knob to adjust the master volume.
If you've connected the AX3G to a guitar amp, set the master vol-
ume to 50.
3. Press the Program Up or Program Down switch to select a program.
The program/value display shows the number of the program you
selected.

Creating your sound (Edit mode)

Signal flow

PRE FX DRIVE/AMP
DELAY / REVERB
MOD
VOLUME PEDAL is available only if a pedal is connected to the PEDAL
jack.
CABINET
NR
VOLUME PEDAL
Edit mode is when the function selector is in one of the [PRE FX]–[DE-
LAY/REV PARAM] positions.
You can change the effect type for each category ([PRE FX], [DRIVE/
AMP], [LEVEL/NR/CAB], [MOD], [DELAY/REV]), and edit the param-
eters to create your sound.
Selecting effects and adjusting the main
parameters
[PRE FX], [DRIVE/AMP], [MOD], [DELAY/REV]
To select the effect you want to use in each of the categories [PRE FX],
[DRIVE/AMP], [MOD], and [DELAY/REV], set the function selector to
the appropriate position and use the [ ][ ] buttons.
The program/value display will indicate a value of F0–F9 (in the case of
DRIVE/AMP, d0–d7 or A0–A7), and the LED at the top of the Program
Down pedal will light to indicate that the program/value display is show-
ing the effect type.
The effect list printed on the panel tells you the effect type that is se-
lected.
You can turn the value knob to adjust the "main" parameter for the se-
lected effect. At this time the program/value display will indicate the value
of the parameter, and the LED at the top of the Program Up pedal will
light to indicate that the program/value display is showing the parameter
value.
To turn an effect on/off, press both the [ ] and [ ] buttons simultaneously.
When an effect is on the effect type is shown, and when an effect is off
the display indicates " ".
Quick guide
When you select an effect, the AX3G automatically sets the parameters
of that effect to their most effective values. In other words, you can cre-
ate great sounds just by choosing an effect for each of the categories
PRE FX, DRIVE/AMP, MOD, and DELAY/REV, without having to make
detailed parameter settings.
AX3G Owner's manual
7