Fusion MS-AM702 User & Installation Manual
Marine zone amplifier
Hide thumbs
Also See for MS-AM702:
- Brochure & specs (5 pages) ,
- User manual (5 pages) ,
- User and installation manual (10 pages)
Advertisement
Advertisement
Table of Contents
Related Manuals for Fusion MS-AM702
Summary of Contents for Fusion MS-AM702
- Page 1 User / Installation Manual Marine Zone Amplifier MS-AM702...
-
Page 2: Table Of Contents
Control Descriptions....Pg 6 When wiring the FUSION amplifier, ensure that the wires are away from sharp objects and that rubber grommets and insulated bungs are used when routing the wiring. -
Page 3: Wiring
Ground Low Level Outputs When grounding your FUSION Amplifier locate a metal area close to the amplifier that is a good source of ground. Use these RCA output connectors to connect to a secondary amplifier. Use either a wire brush or sandpaper to eliminate unwanted paint, rust and corrosion. This will allow a better contact for your ground. -
Page 4: Control Descriptions
PUBLISHED BY FUSION ELECTRONICS LIMITED: YOU CAN HELP PROTECT THE ENVIRONMENT! © Copyright 2008 by FUSION Electronics Limited. Please remember to respect the local regulations: 3: Adjust the LEVEL control until the desired volume is achieved without audible distortion. Remember, the level control is not a All rights reserved. - Page 5 Specifications and design are subject to change without notice.
Need help?
Do you have a question about the MS-AM702 and is the answer not in the manual?
Questions and answers