Eclipse AVN5495 Installation Manual page 10

Connecting the v
Connecting the v
par king br
par king br
• Check the vehicle speed pulse signal, parking brake signal and reverse signal carefully before making
the connections. If the cables are incorrectly connected, accidents or problems with correct operation
may result.
• The label on the vehicle speed pulse signal cable contains a protection circuit, so do not cut the cable
or remove the protective circuit, otherwise problems with operation may result.
• Bind the cables together with tape so that they do not cause an obstruction while driving. If they
become wound around parts such as the steering wheel, shifting lever or brake pedal, accidents may
result.
Tip
The locations where the vehicle speed pulse signal cable, parking brake signal cable and reverse cable
come out vary depending on the vehicle model and grade. Ask the place of car dealer or your nearest
Eclipse dealer for details.
- An example for connecting the vehicle speed pulse signal cable -
Tip
Always be sure to connect the vehicle speed
pulse, otherwise the measurement precision will
be greatly reduced.
1
Use a splicing connector to connect the vehicle
speed pulse signal cable (purple/white) coming
from the main unit to the vehicle speed pulse
signal cable of the vehicle.
2
Route the vehicle speed pulse signal cable to the
main unit.
ehicle speed pulse signal,
ehicle speed pulse signal,
ak e cab le and re
ak e cab le and re
Notes on installation
v erse cab
v erse cab
Vehicle speed pulse
signal cable (vehicle harness)
Vehicle speed pulse
signal cable
(purple/white) of
AVN unit harness
- 10 -
le
le
Engine computer
Splicing connector
7
Contains a protective circuit
so never remove.