Checking Stepping Motors; Checking Sewing Motor; Displaying Error Messages - DURKOPP ADLER 806 Service Instructions Manual

8.7 Checking stepping motors

8.8 Checking sewing motor

8.9 Displaying the emitted error messages
104
Output Function
element
Y60 Advance roller in lower position
Y61 Advance roller in upper position
Y62 Blowing
Y63 Ejection roller in lower position
Y64 Ejection roller in upper position
The programme checks the functions of the stepping motors
This programme shows the programme version, the check sums and
the state of the individual stepping motor controls.
–
Select the function "Checking stepping motors ".
The display shows the software versions of the stepping motors.
–
Press the function key F1 in order to quit the checking programme.
ATTENTION !
The function "Checking the sewing motor " should in no case be
used for 806 with this menu..
For checking the sewing motor use always the function "Sewing
motor ". You will reach the respective menu if you hold the key
"F2" depressed while switching on the machine.
The programme displays the last 10 error messages.
–
Select the function "Error messages".
The display will show the last 10 error messages