Selecting A Startup Device; Selecting A Temporary Startup Device; Selecting Or Changing The Startup Device Sequence; Advanced Settings - Lenovo ThinkStation D20 User Manual

1. Start the Setup Utility program. See "Starting the Setup Utility program" on page 17.
2. From the Setup Utility program menu, select Devices ➙ Legacy diskette A.
3. Select the desired settings and press Enter.
4. Return to the Setup Utility program menu and select Exit ➙ Save and exit the Setup Utility.
Note: If you do not want to save the settings, select Exit the Setup Utility without saving.

Selecting a startup device

If your computer does not start up from a device such as the disc, diskette, or hard disk drive as expected,
do one of the following to select the startup device you want.

Selecting a temporary startup device

Use this procedure to start up from any startup device.
Note: Not all discs, hard disk drives, and diskettes are bootable.
1. Turn off your computer.
2. Repeatedly press and release the F12 key when turning on the computer. When the Startup Device
Menu displays, release the F12 key.
3. Select the desired startup device from the Startup Device Menu and press Enter to begin.
Note: Selecting a startup device from the Startup Device Menu does not permanently change the startup
sequence.

Selecting or changing the startup device sequence

To view or permanently change the configured startup device sequence, do the following:
1. Start the Setup Utility program. See "Starting the Setup Utility program" on page 17.
2. Select Startup ➙ Startup Sequence. See the information displayed on the right side of the screen.
3. Select the devices for the Primary Startup Sequence, the Automatic Startup Sequence, and the Error
Startup Sequence.
4. Select Exit from the Setup Utility menu and then Save Settings or Save and exit the Setup Utility.
If you have changed these settings and want to return to the default settings, select Load Default Settings
on the Exit menu.

Advanced settings

On some computer models, the Advanced settings menu includes a setting to enable or disable
HyperThreading. This feature works only with HyperThreading-aware operating systems, such as Windows
7 and Windows Vista. The default setting for HyperThreading is enabled. However, if you are not using a
HyperThreading-aware operating system and you select Set Defaults for HyperThreading, your computer
performance might be degraded. Therefore, you should always set HyperThreading to Disabled unless you
are sure your operating system supports HyperThreading.

Exiting from the Setup Utility program

After you finish viewing or changing settings, press Esc to return to the Setup Utility program menu (you
might have to press Esc several times). If you want to save the new settings, select Save Settings or Save
and exit the Setup Utility. Otherwise, your changes will not be saved.
.
Chapter 5 Using the Setup Utility
19