Focal iTransmitter User Manual page 2

High Definition Wireless iTransmitter
User manual
2
2. To activate the transmitter synchronization, connect the trans-
mitter to your iPod, iPhone or iPad and push the synchronization
button of the transmitter until the LED quickly flashes. Release
the button.
Info: After a few seconds, the LEDs go on flashing quickly. You
can listen to music, but synchronization is not complete yet. Do
not switch off the receiver or disconnect the transmitter. After
about 20 seconds, both devices will be synchronized and will
flash slowly.
This procedure permits to synchronize a transmitter to a receiver
independently from the associated iPod/iPhone or iPad (only at
first use). Thus, the transmitter can be connected to any iPod/
iPhone or iPad without having to follow this procedure once
again.
HOW TO ASSOCIATE ADDITIONAL TRANSMITTER TO ONE RECEIVER
1. Disconnect any transmitter already associated to the receiver
of your iPod, iPhone or iPad.
2. Repeat instructions 1 to 2 of the previous section.
Several transmitters can be associated to one receiver. Repeat
the procedure to synchronize any extra transmitter.