Download Print this page

Run-In Procedure - Edge ED512 User Manual

Advertisement

INTRODUCTION
This instruction manual is for your safety and must be adhered to at all times. Please read and
ensure that you fully understand the installation and set up procedures as explained. If you
are unclear on the installation or set up of your EDGE speakers please contact your nearest
authorised EDGE dealer.
DO NOT EXPOSE THIS PRODUCT TO DAMP OR MOISTURE - doing so may result in fire,
shock or damage to the product.
BEFORE WIRING DISCONNECT THE CABLE FROM THE POSITIVE BATTERY TERMINAL -
failure to do so may result in electric shock or injury.
ENSURE GOOD AND CORRECT CONNECTIONS - failure to make the correct connections
may result in fire or damage to the product.
DO NOT USE ANY FUNCTIONS OF THIS EQUIPMENT THAT MAY TAKE YOUR
CONCENTRATION AWAY FROM DRIVING YOUR VEHICLE - do not set up your amplifier
whilst driving, doing so may result in an accident. For prolonged setting up, make sure that
your vehicle is stationary and in a safe location.
KEEP THE VOLUME AT A LEVEL SO YOU CAN STILL HEAR OUTSIDE NOISE - failure to do
this may result in an accident. EDGE equipment is capable of producing sound levels that can
permanently damage your hearing. EDGE recommends caution when listening at high volume.
For safe and enjoyable listening the sound should be comfortable and clear without distortion.
Never connect any speaker lead to the car chassis. This can cause severe damage to your
speaker /car radio /amplifier.
Before drilling or cutting any holes, investigate the layout of your vehicle thoroughly.
Use caution when working near the fuel / hydraulic lines and electrical wiring.
Observe the correct polarity when wiring, improper phasing may cause a loss of bass
Ensure that no moving parts catch on the speaker or grill (e.g. window or door handles, or
window glass inside the door)
Contents
1x EDGE woofer
8 x Fixing screws
Warranty card
WARNING
CAUTION
response.
Run in procedure
EDGE recommends that you follow the run in procedure for the subwoofer detailed below.
When your Subwoofer is used for the first time, like most brand new items it is naturally very
stiff and rigid. It will take time for the moving parts of this Subwoofer to loosen up before the
Subwoofer will be ready to deliver its full potential.
For the first 30 hours it is recommended that you play the Subwoofer initially at low to medium
volumes, gradually increasing the volume level as time progresses.
As a guide, if you listen to your Subwoofer for 1 hour every day it will take a month for the
subwoofer to run in properly.
You will notice a big change in the sound of the Subwoofer over this period. As the spider and
surround begin to run in the sound will get deeper and harder, also the output of the Subwoofer
will increase as the suspension loosens up.
The Subwoofer is like your car's engine, it needs a few thousand miles before you can drive it to
its full potential. Driving it into the redline from the first day will mean engine damage is certain
and will not be covered by warranty.
Failure to follow this simple procedure is the most common reason for a Subwoofer to fail after a
very short period of time.
Wiring options
The EDGE subwoofer has a dual 2 ohm voice coil. Below are a few different wiring examples,
please check with your amplifier
Single woofer configuration
+
-
-
+
-
-
+
+
-
-
+
+
-
-
+
-
+
-
+
1Ohm parallel
4 Ohm series
Twin woofer configuration
-
-
+
+
-
-
+
+
+
+
-
-
+
+
-
-
+
+
+
2 Ohm series / parallel
+
+
-
-

Advertisement

loading

This manual is also suitable for:

Ed515Ed510