Procedure 1 External Display Check; Procedure 2 Diagnostic Check - Toshiba Satellite M30X Maintenance Manual

2.4 Display Troubleshooting
This section describes how to determine if the computer's display is functioning properly. The
process is outlined in Figure 2-3. Start with Procedure 1 and continue with the other procedures
as instructed.
Procedure 1: External display check
Procedure 2: Diagnostic check
Procedure 3: Connector and replacement check
Procedure 1 External display check
Connect an external display to the computer's external monitor port, then boot the computer.
The computer automatically detects the external display.
If the external display works correctly, the internal LCD may be damaged. Go to Procedure 3.
If the external monitor appears to have the same problem as the internal monitor, the system
board may be damaged. Go to Procedure 2.
Procedure 2 Diagnostic check
The Display Test program is stored on the computer's Diagnostics disk. This program checks the
display controller on the system board. Insert the Diagnostics disk in the computer's floppy disk
drive, turn on the computer and run the test. Refer to Chapter 3, Tests and Diagnostics for
details.
If an error is detected, go to Procedure 3. If an error is not detected, the display is functioning
properly.
Satellite M30X Series Maintenance Manual
2 Troubleshooting Procedures
2-13