Dual XDVD3101 Installation & Owner's Manual page 27

Watching Video
Parking Brake Initialization
DVD Setup - Parking Brake Initialization
• The video display of the in-dash unit will not operate while the vehicle is
moving. This is a safety feature to prevent driver distraction. In-dash video
functions will only operate when vehicle is in Park and the PARKING BRAKE
is engaged. It is illegal in most states for the driver to view video while the
vehicle is in motion. Refer to local laws in your area.
• The vehicle must be in park and the parking brake applied to view video on the
in-dash monitor.
• As a safety feature, !!Safety Warning!! blue screen will show on the display
when the vehicle's parking brake is not engaged. Video display on the in-dash
monitor isn't allowed until the PARKING BRAKE is engaged. Connect the
yellow/blue PARKING BRAKE wire to the brake switch circuit
on page 6. Note: DVD and AUX AV audio can be heard while the vehicle is in
motion without engaging the parking brake.
Follow these two initialization procedures carefully to allow video playback on
the XDVD3101 in-dash monitor:
There are two ways to initiate the PARKING BRAKE sequence.
If vehicle is moving:
1) Stop vehicle, put in Park, make sure PARKING BRAKE is off/released.
2) Depress PARKING BRAKE for 1 second.
3) Release PARKING BRAKE for 1 second.
4) Depress PARKING BRAKE permanently.
If vehicle is already parked and the PARKING BRAKE is already applied:
1) Keep vehicle in Park, PARKING BRAKE should be on.
2) Release PARKING BRAKE for 1 second.
3) Depress PARKING BRAKE for 1 second.
4) Release PARKING BRAKE for 1 second.
5) Depress PARKING BRAKE permanently.
Note: The parking brake transition time must be less than 2 seconds between
depress and release. This procedure must be repeated anytime the unit or
vehicle ignition is turned off.
XDVD3101 OPERATION
SAFETY WARNING
as described
26