Dual XDMA6540 Installation & Owner's Manual page 7

XDMA6540 OPERATION
General Operation
Volume Adjust volume using volume knob (00-46).
Mute Press MUTE to silence the audio. "MUTE" will flash in
the display. Press MUTE again to cancel.
Display
Press DISP to toggle between items such as ID3 tag
song information, file/folder information or the clock.
Select / Tag Push the volume knob inward to activate the SELECT
function. Push and hold the volume knob inward to
activate the TAG function.
Steering Wheel The steering wheel interface input located on the back
Interface Input of the head unit allows connection to the PAC (Pacific
Accessory Corporation) SWI-PS interface module
(sold separately). Visit www.pac-audio.com for details.
To configure steering wheel controls, follow the
instructions provided with the PAC SWI-PS interface
module. After installing the interface module, insert
the module's 3.5mm jack into the port labeled
"REMOTE IN" on the back of the head unit.
Auxiliary Inputs The XDMA6540 features two auxilary inputs. Insert
a 3.5mm connector in the front panel AUX port, or
connect RCA-type cables into the rear AUX port. Press
MODE UP/DOWN to select Aux Front or Aux Rear
modes.
Reset
Press the RESET button, located behind the front
panel, to reset the unit back to the factory settings if
abnormal operation occurs.
Setting the Clock
With the unit on, press and hold DISP until the clock
nn
begins to flash, then release. Press TUNE
ll
to adjust the hours and TUNE to adjust the
minutes. Press DISP momentarily to save the selected
time.
Note: The clock can also be set in the GENERAL
menu. See page 11 for details.
12/24-Hour Clock The clock will display 12-hour AM/PM time in USA
frequency spacing mode (PM 10 : 00). In European
frequency spacing mode, the clock will display
24-hour time (22:00).
Note: 24-hour time and European frequency spacing
are not available if the HDM90 HD Radio™ tuner are
connected.
7