Sansui HDPDP5050 Owner's Manual page 21

To connect the Plasma TV to a PC (Personal Computer)
Before you connect this Plasma TV to your PC, change the adjustment of your PC's Resolution and Refresh
rate (60 Hz).
Connect one end of a (male to male) VGA cable to the video card of the computer and the other end to the
VGA connector PC MONITOR on the back of the Plasma TV. Attach the connectors firmly with the screws on
the plug. In case of a Multimedia computer, connect the audio cables to the audio outputs of your Multimedia
computer and to the AUDIO L and R connectors of the PC AUDIO / HDMI-1 AUDIO (L/R) IN jacks of the
Plasma TV.
Press INPUT SELECT on the remote control to select PC mode.
Switch on the computer. The Plasma TV can operate as the computer monitor.
Rear lower of the Plasma TV
To PC IN
NOTES:
•
The on-screen displays will have a different appearance in PC mode than in TV mode.
•
When you select WXGA or WVGA mode, see the WXGA INPUT or WVGA INPUT to ON in the PC
PICTURE menu (see page 49).
Connections to other equipment
To PC AUDIO/HDMI-1
AUDIO (L/R) IN jacks
Audio cord (not supplied)
VGA cable (not supplied)
Monitor Display modes
MODE Resolution
VGA 640x480
WVGA 848x480
SVGA 800x600
XGA 1024x768
WXGA 1280x768
WXGA 1280x720
To return to normal mode
Press INPUT SELECT again.
Refresh rate
60Hz
60Hz
60Hz
60Hz
60Hz
60Hz
21