Sansui HDPDP5050 Owner's Manual page 19

To connect the Plasma TV to a HDMI or a DVI device
The HDMI input receives digital audio and uncompressed video from a HDMI device or uncompressed digital
video from a DVI device.
When you connect to a DVI device with a HDMI-to-DVI adapter cable, it transfers only the video signal. Separate
analog audio cords are required.
NOTES:
•
You must choose an appropriate setting for each connection (see "Selecting the HDMI audio input source" on page 46).
•
You can also use HDMI-1 IN for DVI device connection. In this case, you must connect the audio cables to AUDIO L/R, not
AUDIO.
Using an AV Amplifier with built-in digital surround
If you are using an Amplifier with built-in digital surround sound, you can enjoy various audio systems including
Dolby Digital Surround audio that sounds just like the movie.
Connect an AV amplifier with built-in Dolby Digital decoder, or etc as shown below.
Rear lower of the Plasma TV
Coaxial Digital Audio Output
Optical Digital Audio Output
Coaxial digital cable
(not supplied)
Optical
digital
To Coaxial Digital Audio Input
cable (not
supplied)
To Optical Digital
Audio input
AV Amplifier with built-in digital surround
decoder as listed above
NOTES:
•
When you make the connection above, on the AV Amplifier, do not set DOLBY DIGITAL to DOLBY DIGITAL "ON". If you do, a
loud noise will emit from the speakers possibly causing damage to your hearing or to the speakers.
•
This unit does not apply to DTS audio. There will be no sound output if connected to AV amplifier with built-in DTS decoder.
Connections to other equipment
Rear lower of the Plasma TV
Audio cord (not supplied)
HDMI - to - DVI adapter cable
(HDMI type A connector)
(not supplied)
To DVI output
HDMI cable (type A connector)
(not supplied)
To HDMI out
Front
Speaker
(Left)
DVI device
or
HDMI device
Subwoofer
TV
Center Speaker
Surround
Speaker (Left)
Front
Speaker
(Right)
Surround
Speaker
(Right)
19