Multi-Colored Spa Light Operation; Waterfalls - Cal Spas LTR20101001 Owner's Manual

automatically and the green LED light on the panel
will continue to blink for one minute then shut off
automatically. After the second 15-minute session,
the system will run through a cool down cycle for up
to two hours. In this cool down mode, the user will
only be able to operate the pump (by again pressing
the "PUMP ON/OFF" button). However, the massage
mode will remain off until the cool down mode is
completed.
Pulse Mode System
Pulse mode system will shut off for two hours unless
reset by the following procedure. During this time the
pump will run at a maximum speed.
• In the off position, press the "PULSE MODE"
button once.
• The green power light will flash to indicate reset.
Multi-Colored Spa Light
Operation
1. Turn the spa light on by pressing the "LIGHT"
button on the topside control panel.
2. To filter through the different color choices, press
the button on and off. Each time you press the
button, you advance to the next color.
3. To turn the spa light off when not in use, press the
"LIGHT" button.

Waterfalls

Some spa series include optional waterfalls. When the
booster pump is on, turn the knob near the waterfall.
Water will immediately start flowing through it.
2010 Portable Spa
LTR20101001, Rev. B
21
www.calspas.com