DAVIS Vantage Pro2 6312 Console Manual page 55

If the transmitter ID being repeated is displayed and an "X" flashes in the bottom
right corner of the ticker tape, the transmitter is being repeated and received by the
console successfully.
The repeater's information also displays at the bottom of the console's diagnostics
screens.
Clearing Repeater ID
If a repeater ID is being displayed in Screen 2 and you are not using a repeater with the
selected station, you must turn off the repeater function to receive station information
successfully.
In Setup Screen 2:
Press 2ND and then press WIND repeatedly so that the console cycles through the list
of repeater IDs (Repeaters A-H) until the section where the repeater ID was displayed
is blank. Press DONE to continue to the next screen or press and hold DONE to return
to the Current Weather Mode.
52