Program Setting - Equinox Systems Equinox DVD1045E Instruction Manual

Remote control
Some features of the player can only be performed
by the remote control.
Some features described in this owner's manual are
related to the Disc's encoding.
Some features may not be available, if the disc
encoding does not support the feature.
REV
F W D
34
33
PREV
32
NEXT
31
N/P
PBC
30
29
STOP
28
27
(
)
MOVE
26
SETUP
25
ANGLE
24
23
VIDEO
22
21
20
RETURN
REPEAT
0-9 NUMBER KEY
GOTO
STEP
POWER
34
Notes
The remote control transmits a directional infrared beam. Be sure to aim
the remote control directly at the infrared sensor during operation. When
the sensor is covered or there is a large object between the remote control
and the sensor, the sensor cannot receive signals. The sensor may not be
able to receive signals properly when it is exposed to direct sunlight or a
strong artificial light (such as a f luorescent or strobe light). In this case,
change the direction of the light or reposition the unit to avoid direct lighting.
INTRODUCTION
REMARK
Some features contained in this DVD player are
related to theDVD Disc's software.
Some features cannot be performed if the disc does
not support the feature, or requires special settings.
Check the features printed on the disc's packing or
follow the instructions of the Disc's on screen menu.
OPEN/CLOSE
PROGRAMME
1
2 MUTE
3
AUDIO
4
SUBTITLE
5
6
ZOOM
7
8
9 A-B
10
11
VIDEO
OSD
12
13
MENU
14
VOL+
15
SLOW
16
17
18
VOL-
19
DVD 1045E
L/R
ENTER
PLAY
TITLE
PAUSE
5

Program setting

P rogram to play a DVD, CD and MP3 disc in a desired sequence automatically
Load a DVD disc.
DVD program menu
1
2
Program Input Title/Chapter
1 __ __
4 __ __ 7 __ __ 10 __ _ _
2 __ __ 5 __ __ 8 __ __ 11 __ __
3 __ __ 6 __ __ 9 __ __ 12 __ _ _
Play Program Clear All
3
4
5
Load a CD disc.
SVCD,VCD,CD,MP3
program Menu
1
2
Program Input
3
1 ___
4 ___ 7 ___ 10 ___
2 ___ 5 ___ 8 ___ 11 ___
3 ___ 6 ___ 9 ___ 12 ___
Play Program Clear All
4
5
NOTE
Some DVD discs do not allow
programming.
Single track disc cannot be
programmed.
FUNCTION BUTTONS
PROG
PROG
Press the Button in stop mode,
the DVD program menu will appear .
Use numeric key pad
to input the Title number and the Chapter number,
Repeat step 2 until programming is completed.
Highlight "Play Program", to start the program.
Highlight "Clear All", to clear all input.
ENTER
Press button to confirm.
ENTER
PROG
PROG
Press button to exit the program menu.
PROG
PROG
Press button to cancel the program.
PROG
PROG
Press the Button in stop mode,
the CD program menu will appear .
Use numeric key pad
to input the Track number
Repeat step until programming is completed.
2
Highlight "Play Program", to start the program.
Highlight "Clear All", to clear all input.
Press ENTER button to confirm.
ENTER
PROG
PROG
Press button to exit the program menu.
PROG
Press PROG button to cancel the program.
18