Equinox Systems Equinox DVD1045E Instruction Manual page 3

Installation Warnings
Ventilation ?Slots and openings in the case are
provided for ventilation to ensure reliable operation
of the video product and to protect it from overheating.
These openings must not the blocked or covered. The
openings should never be blocked by placing the
product on a bed, sofa, rug, or heat register. This
product should not be placed in a built-in installation
such as a bookcase or rack, unless proper ventilation
is provided or the video product manufacturer
instructions have been followed.
Outdoor Antenna Grounding ?If an outside antenna
or cable system is connected to the video product,
be sure the antenna or cable system is grounded
so as to provide some protection against voltage
surges and builtup static charges. ANSI/NFPA
No. 70-1984 provides information with respect to
proper grounding of the mast and supporting
structure, grounding of the lead-in wire to an
antenna-discharge unit, connection to grounding
electrodes, and requirements for the grounding
electrode.
Power Lines ?An outside antenna system should
not be located in the vicinity of overhead power
lines, other electric light or power circuits, or where
it can fall into such power lines or circuits. When
installing an outside antenna system, extreme care
should be taken to keep from touching or approaching
such power lines or circuits, as contact with them
might be fatal. Installing an outdoor antenna can
be hazardous and should be left to a professional
antenna installer.
Lightning ?For added protection for this product
during a lightning storm, or when it is left unattended
and unused for long periods of time, unplug it from
the wall outlet and disconnect the antenna or cable
system. This will prevent damage to the video
product due to lightning and power line surges.
SAFETY INFORMATION
Compulsory Warnings
If the supply cord is damaged, it must be replaced
by the manufacturer or its service agent, or a similarly
qualified person, in order to avoid a hazard. This
product has not been designed for any uses other
than those specified in this booklet.
Laser Safety
This compact disc player is classified as a CLASS 1
LASER PRODUCT.
Only qualified service personnel should remove the
cover or attempt to service this device due to
possible eye injury.
Invisible laser radiation when open and interlock
failed or defeated.
Avoid direct exposure to beam.
TROUBLE SHOOTING
CAUTION
CAUTION
shock, do not remove the cover (or back) of the unit. Refer
RISKOF ELECTRIC SHOCK
DO NOT OPEN
servicing only to qualified service personnel.
Symptom Check and Action
Cannot SKIP Some discs are programmed that do not allow users to SKIP
or SEARCH
at some sections, especially
Single Chapter disc cannot apply SKIP function.
No sound or Check if the TV and Amplifier have been switched on, and correctly set.
sound output
not complete Check if the TV and Amplifier system connection is
Press AUDIO button to select other audio tracks output
Check if the MUTE function of the TV or Amplifier has been
There will be no sound output during PAUSE / STEP / SLOW .
No surround If digital output has been applied:
sound Press SETUP button
Highlight "AUDIO"
Highlight "Digital Out"
Select RAW or PCM
Press SETUP button
Power on the amplifier or active
MP3 disc no When PC program files or other data files are mixed with
sound or noisy
MP3 files in the same disc, the player may play the non-MP3
files with noise or no sound.
Check the disc, if all the files on disc are MP3 files
Skip the f ile, try other files.
Remove the obst acles between the remote control and the player .
Remote control
does not function
Point the remote control towards the remote sensor on the player.
Check if the batteries of the remote control have
correct polarities.
Replace the batteries of the remote control.
: To reduce the risk of fire and electric
at the beginning WARNING section.
secured.
of disc.
activated.
type loudspeakers.
been loaded with
24