Equinox Systems Equinox DVD1045E Instruction Manual page 6

SETUP
Various features of the player can be adjusted in
the SETUP menu:
Press SETUP button
SETUP menu appears.
Highlight the desired icon Press ENTER
ENTER
button to activate the setting sub menu.
Language
Enter this menu to setup the language in
OSD display, DVD disc subtitle, DVD disc audio
and DVD disc start menu.
Press SETUP button
Highlight "Language",
Press ENTER , Language sub menu appears.
ENTER
English
OSD menu
Francais
Subtitles
DVD menu
Highlight the desired item and press ENTER button,
Highlight the desired item,
Press ENTER button to confirm.
ENTER
Press SETUP button to save the setting and quit.
OSD menu
Subtitles
DVD menu
Video
Enter this menu to setup the video setting
Press SETUP button
Highlight "Video",
Press ENTER , Video sub menu appears.
ENTER
Highlight the desired item and press ENTER button,
Highlight the desired item,
ENTER
Press ENTER button to confirm.
Press SETUP button to save the setting and quit.
4:3 PS
TV screen
The aspect ratio of the picture provided by the DVD
player can be varied in line with the features available
on the TV in use.
4:3 Letter Box
Allow you to see movies in their
original aspect ratio.
Entire frame of the movie will
be display on screen, but it will
occupy a smaller portion of the
screen.
4:3 Pan Scan
The signal will fill the
screen with the centre
of the picture. The left
and right edge of
picture may be cut
outside range of the
screen.
21
INTRODUCTION
THE REMOTE CONTROL
Loading batteries to the remote control
Remove the battery compartment cover.
Load two AAA batteries into the battery compartment.
Make sure that the batteries have been inserted
in the correct polarities matching to the symbols
+, - marked in the battery compartment. Close
the battery compartment cover.
When replacing batteries, replace both batteries.
Do not mix new and used batteries operating
together, otherwise, the operation lifetime will
be much shorter than normal.
Remove the batteries if the unit will not be used
for a prolonged period of time.
The remote control transmits a directional
infrared beam.Be sure to aim the remote
control directly at the infrared sensor of the
unit during operation.
If the sensor has been covered or there is a
large object between the remote control and
the sensor, the sensor will not respond.
The sensor may not able to receive the
remote signal when it is exposed to direct
sunlight or a strong artificial light (fluorescent
or strobe light). In this case, change the
direction of the light or reposition the unit to
avoid direct lighting.
BE ENVIRONMENTALLY FRIENDLY
Do not dispose of batteries as normal rubbish. Be environmentally friendly,
dispose of batteries following the Government's regulation.
DVD 1045E DVD/VCD/CD/MP3 PLAYER
Within approximately
6 meter (20 feet)
30 30
VIDEO
DVD 1045E
2
POWER