Table of Contents
Advertisement
b-2) Input to RESET
If the Low level is applied to the RESET pin for 4 ms or more, the power-down mode is reset. However,
unless oscillation is stabilized, it is necessary to set the RESET pin to the Low level. After oscillation is
stabilized, set the RESET pin to the High level.
This initializes the inside of the unit and starts it in about 100 ms.
D0 through D7 are dot points in each position:
"1" for a point, and "0" for a space.
When n1, n2, n3, are specified beyond their ranges, or when n2=n3=0 is specified, the text mode results with the
bit image mode cancelled.
Since this printer prints by 4-dot line, insufficient data is printed as a space after reading in the 4-dot line worth of
data or when the n1, n2, n3, specified data is completed.
IN the MD-910 specifications, when n1,=23 is specified, the 4 dots from the most significant dot (MSC DOT) are
invalidated. This is because there are 180 dots fro one-line printing positions.
Although the text mode has been restored after bit image printing, the line space=0 has been assumed.
Therefore, it is necessary to perform line feed before printing in the text mode.
Note)
For bit image printing, inverted printing is not performed even if R-type is specified.
c.
International character setting; ESC + R + n
The ESC + R + n command specifies the following character table of each country.
"n" other 0 to 8 is invalid (not changed).
n=8 (Japan) is set at power-on or after a reset.
n
Country
0
U.S.A
1
France
2
Germany
3
Britain
4
Denmark
20
CBM-909PC Series User'sManual
n
Country
5
Sweden
6
Italy
7
Spain
8
Japan
Advertisement
Table of Contents
