Citizen CBM-262 II Command Reference Manual page 12

(2) n = 2: In case of status caused by an offline condition
0 Unused
1 Unused
2 Lever open
3 Paper feed by paper feed switch
4 Unused
Printing stop because of
5
"paper out" state
6 Error occurred
7 Unused
Bit 5: If the paper end detector detects a "paper out" state, or the paper near-end sensor is enabled by ESC
C4, printing will be stopped. At this time, bit 5 = 1.
N = 3: In case of status caused by an error
Bit
0 Unused
1 Unused
2 Undefined
3 Auto Cutter error occurred
4 Unused
5 Unrecoverable error occurred
6 Auto recovery error occurred
7 Unused
Bit 3: If this error occurs due to causes such as a paper jam, remove the cause of the error.
Then DLE ENQ n (1<n<2) can be used to recover from the error.
It is not possible, however, to recover from any error due to defect in hardware or mechanism.
Bit 6: If a head overheat is detected, it will become "1". If the temperature falls, it will become "0".
N=4: In case of paper detector status
Bit
0 Unused
1 Unused
2 Detecting Journal Near-end
3 Detecting Receipt Near-end
4 Unused
5 Detecting Journal paper-end
6 Detecting Receipt paper-end
7 Unused
CITIZEN
Not in paper feed state
Function
Function
TITLE:
PB-32/33
Value
0
Fixed at 0
Fixed at 1
Lever closed Lever opened
In paper feed state
Fixed at 1
No stopping Stopping
Not occurred Occurred
Fixed at 0
Value
0
Fixed at 0
Fixed at 1
−
No error Error occurred
Fixed at 1
No error Error occurred
No error Error occurred
Fixed at 0
Value
0
Fixed at 0
Fixed at 1
Paper found Paper not found
Paper found Paper not found
Fixed at 1
Paper found Paper not found
Paper found Paper not found
Fixed at 0
SHEET
REVISION
1
1
−
1
B
8/85
8