Sansui LCDWDVD320 Owner's Manual page 55

Connections to other equipment
To connect a HDMI or a DVI device to the unit
The HDMI input receives digital audio and uncompressed video from a HDMI device or uncompressed digital
video from a DVI device.
When you connect to a DVI device with a HDMI-to-DVI adapter cable, it transfers only video signal. Separate
analog audio cords required.
Rear lower left of unit
HDMI - to - DVI adapter cable (HDMI type A connector)
NOTE:
You must choose an appropriate setting for each connection (see page 32. "Selecting the HDMI audio input
source").
Using an AV Amplifier with built-in digital surround
If you are using an Amplifier with built-in digital surround sound, you can enjoy various audio systems including
Dolby Digital Surround audio that sounds just like the movie.
Connect an AV amplifier with built-in Dolby Digital decoder, DTS decoder, or MPEG decoder etc. as
shown below.
Rear lower left of unit
Coaxial Digital Audio Output
Coaxial digital cable
(not supplied)
To Coaxial Digital Audio Input
AV Amplifier with built-in digital surround
decoder as listed above
*
Manufactured under license from Dolby Laboratories. "Dolby" and the double-D symbol are trademarks of Dolby
Laboratories. Confidential unpublished works.
*
"DTS" and "DTS Digital Out" are trademarks of Digital Theater Systems, Inc.
NOTES:
•
When you make the connection above, on the AV Amplifier, do not set DOLBY DIGITAL to DOLBY DIGITAL, or MPEG to
MPEG "ON". If you do, a loud noise will emit from the speakers possibly causing damage to your hearing or to the speakers.
•
Some DTS decoders do not support DVD-DTS interface, and may not work properly with the unit.
HDMI cable (type A connector)
(not supplied)
(not supplied)
Audio cord (not supplied)
Front
Speaker
(Left)
(continued)
HDMI device
To HDMI out
DVI device
To DVI output
Subwoofer
TV/DVD
Center Speaker
Surround
Speaker (Left)
or
Front
Speaker
(Right)
Surround
Speaker
(Right)
55