Operation And Usage; Channel Routing Aeb4-O - RME Audio AEB4/8-0 User Manual

7. Operation and Usage

The AEB works like any other device having an ADAT input, but is located inside your computer.
Please note that the AEB requires the DIGI96/8 to send the output format 'ADAT'. Therefore
using the DIGI96/8 series 'Force ADAT' should be activated in the DIGI's Settings dialog.
Two LEDs on the AEBx-O serve as useful error indication. The green LED is lit when the power
supply is present. The red LED is lit when the digital input signal is no ADAT format or not reli-
able. This will happen when the card is still sending SPDIF, or no signal at all is present at the
connector DIG IN.

8. Channel Routing AEB4-O

The AEB4-O is designed for maximum flexibility. Jumpers J5 and J6 allow to route digital chan-
nels 1/2 or 5/6 to analog output 1 and 2, and digital channels 3/4 or 7/8 to analog output 3 and 4.
The jumper setting is printed on the board.
In combination with DIGI96/8 PRO, PST or PAD six analog outputs are available, due to the
cards own stereo analog output.
The default setting of the jumper J5/J6 is 1/2 and 3/4. In this case the track button of the DIGI's
analog output should be set to 5/6 or 7/8, to gain 6 different and independent analog outputs.
In case the DIGI's analog output shall playback channel 1/2 and the AEB channels 3/4 and 5/6,
the jumpers have to be set accordingly.
Please note that in this case the channel order according to the jacks seems to be swapped
(jack 1 plays channel 5, jack 2 channel 6, jack 3 channel 3 and jack 4 channel 4).
User's Guide AEB4/8-O
6