Making The Electrical Connections; Mounting The Glass Canopy - Electrolux EI30WC60GS Installation, Use & Care Manual

Making the electrical connections

Electrical Shock Hazard
Warning: Turn off power at the service panel before
wiring this unit.
120 V 120 V AC, 15 or 20 Amp cir AC, 15 or 20 Amp cir
120 VAC, 15 or 20 Amp cir 120 V 120 V AC, 15 or 20 Amp circuit r AC, 15 or 20 Amp cir
ELECTRICAL GROUNDING INSTRUCTIONS ELECTRICAL GROUNDING INSTRUCTIONS ELECTRICAL GROUNDING INSTRUCTIONS ELECTRICAL GROUNDING INSTRUCTIONS ELECTRICAL GROUNDING INSTRUCTIONS
THIS APPLIANCE IS FITTED WITH AN ELECTRICAL
JUNCTION BOX WITH 3 WIRES, ONE OF WHICH
(GREEN/YELLOW) SERVES TO GROUND THE
APPLIANCE. TO PROTECT YOU AGAINST
ELECTRIC SHOCK, THE GREEN AND YELLOW
WIRE MUST BE CONNECTED TO THE
GROUNDING WIRE IN YOUR
HOME ELECTRICAL SYSTEM, AND IT MUST
UNDER NO CIRCUMSTANCES BE CUT OR REMO-
VED.
Failur Failur e to do so can r e to do so can r esult in death or electrical esult in death or electrical
Failur Failure to do so can r Failur e to do so can r e to do so can result in death or electrical esult in death or electrical esult in death or electrical
shock. shock. shock.
shock. shock.
• Remove junction box cover and knockout on the
top left side.
• If not already done, install 1/2" conduit connector
in j-box.
cuit r cuit r equir equir ed. ed.
cuit requir cuit r equired. equir ed. ed.
Knockout
Junction box
cover
Installing the hood
House
wiring
U.L. listed
wire nut
• Run black (live), white (neutral), and green (earth)
wires (#14 AWG) according to the National
Electrical Code or CSA Standards and local
codes and ordinances in 1/2" conduit from power
supply to j-box.
• Connect black, white, and green wires from
power supply to black, white, and green/yellow
wires in j-box respectively.
• These connections should be done always
making reference to the electrical diagram found
inside the hood.
• Close j-box cover and reapply screws.

Mounting the glass canopy

Mounting the glass canopy Mounting the glass canopy Mounting the glass canopy Mounting the glass canopy
• With the hood mounted on the wall slide the glass
canopy over the glass supports.
• Insert the glass brackets.
• Insert two screws into the bracket holes, drive the
screws by hand.
13 13
13
13 13
Metal electrical
conduit