Ceiling Ducting; Making The Electrical Connections - Electrolux RH36PC60GS Installation, Use & Care Manual

Ceiling ducting

Ceiling ducting Ceiling ducting
Ceiling ducting Ceiling ducting
• Use the template previously installed to prepare a
8-½" hole in the ceiling for ductwork.
8 1/2"
8.43" - 10"
minimum ceiling
7.93" - 10"
minimum ceiling

Making the electrical connections

Electrical Shock Hazard
Warning: Turn off power at the service panel before
wiring this unit.
120 VAC, 15 or 20 Amp cir 120 V 120 V 120 V 120 V AC, 15 or 20 Amp cir AC, 15 or 20 Amp cir AC, 15 or 20 Amp cir AC, 15 or 20 Amp circuit r
ELECTRICAL GROUNDING INSTRUCTIONS ELECTRICAL GROUNDING INSTRUCTIONS ELECTRICAL GROUNDING INSTRUCTIONS
ELECTRICAL GROUNDING INSTRUCTIONS ELECTRICAL GROUNDING INSTRUCTIONS
THIS APPLIANCE IS FITTED WITH AN ELECTRICAL
JUNCTION BOX WITH 3 WIRES, ONE OF WHICH
(GREEN/YELLOW) SERVES TO GROUND THE
APPLIANCE. TO PROTECT YOU AGAINST
ELECTRIC SHOCK, THE GREEN AND YELLOW
WIRE MUST BE CONNECTED TO THE
GROUNDING WIRE IN YOUR
HOME ELECTRICAL SYSTEM, AND IT MUST
UNDER NO CIRCUMSTANCES BE CUT OR REMO-
VED.
4 12/16" (At least)
23 12/16"
30" Gas Cooktop (min)
24" - 30" Electric Cooktop (min)
cuit requir cuit r cuit r cuit r equired. equir equir equir ed. ed. ed. ed.
Installing the hood
Failure to do so can r Failur Failur e to do so can r e to do so can r e to do so can result in death or electrical esult in death or electrical esult in death or electrical esult in death or electrical
Failur Failur e to do so can r esult in death or electrical
shock. shock. shock. shock. shock.
• Remove junction box cover and knockout on the
top left side.
• If not already done, install 1/2" conduit connector
in j-box.
House
wiring
U.L. listed
nut
• Run black (live), white (neutral), and green (earth)
wires (#14 AWG) according to the National
Electrical Code or CSA Standards and local
codes and ordinances in 1/2" conduit from power
supply to j-box.
• Connect black, white, and green wires from
power supply to black, white, and green/yellow
wires in j-box respectively.
• These connections should be done always
making reference to the electrical diagram found
inside the hood.
• Close j-box cover and reapply screws.
Knockout
Junction box
cover
Metal electrical
conduit
11 11
11
11 11