Dual Outputs - Cary Audio Design SLP-98 Operating Manual

AUX.-CD-TUNER-TAPE:
GND:
MONITOR:
TAPE OUT:

DUAL OUTPUTS:

AC:
Never remove/insert AC line cord when the unit is "ON"
This section describes the unpacking and installation procedures for the SLP-98 preamplifier.
Make no attempt to put the preamp in service
Contact with voltage in the SLP-98 can be fatal!!
All shipping containers have been specially designed to protect their contents and special care has
been taken to prevent damage under normal shipping conditions. Mishandling should be evident
upon inspection of the shipping container. If damage is found after visual inspection, take care not
to destroy the evidence. If necessary, document the damage with photographs and contact the
transport carrier immediately.
These are line level inputs requiring flat frequency response
Ground lug for turntable chassis
For use with tape recorders that employ a third head to monitor a
tape as it is being recorded (may be used as a flat frequency
response line input)
Constant output of selected input signal for recording independent
of volume control setting on SLP-98
1-Connect directly to input of power amps
Multi-conductor power cord to be plugged into SLP-98 external
power pack
CAUTION
INSTALLATION AND UNPACKING
WARNING
outside of the cabinet.
2.1 Unpacking
4