Electrolux Loopie Z2950 Series Owner's Manual page 11

PROBLEM SOLVING
CAUTION: Turn off the switch and unplug the electrical cord before servicing.
Problem
Motor will not start
Motor stops suddenly
Does not clean the carpet or floor
No suction at the end of hose
Noise from the brushroll area
Cleaner is hard to push
Cleaner height knob will not turn
Missing parts
Questions
Cause
Electric Plug
Thermal Cut Off
Filters
Dust Cup
Hose
Belt
Brushroll
Hose Adapter
Filters
Hose
Dust Cup
Brushroll
Belt
Cleaner Height Setting
Belt
Cleaner Height Setting
• Push plug securely into outlet
• Try another outlet
• Check circuit breaker
• Refer to page 2
• Clean or replace filters. Hint: If picking up fine dust, the filters may
not look dirty, but a fine substance tends to reduce suction when
it blocks the air flow through the filter(s). Pages 7-8.
• Empty dust cup. Check to ensure cup is properly seated and secured
with lever engaged. Hint: Be sure both top and bottom filters are in place.
• Be sure hose adapter is secure on back of cleaner. Page 10.
• Remove any blockages from the hose that restricts the air flow. Page 10.
• Check to see that the end of the hose is firmly pressed into the hose
retainer in the hood of the vacuum. Page 10.
• Check base hose and long hose. Page 10.
• Replace a broken, cut, loose or out of shape belt. Page 9.
• Clean hair and thread from bristles and end cap area.
• Replace brushroll if bristles are worn. Page 9.
• Be sure hose adapter is secure. Page 10.
• Clean or replace filters. Hint: If picking up fine dust, the filters may
not look dirty, but a fine substance tends to reduce suction when
it blocks the air flow through the filter(s). Page 7-8.
• Remove any clogs from hose that restricts the air flow. Check base
hose and long hose. Page 10.
• Empty dust cup. Check to insure cup is properly seated and secured
with lever engaged. Hint: Be sure both top & bottom filters are in place.
Page 7-8.
• Remove hood and clean debris or items from the brushroll area.
Page 9.
• Replace a broken, cut, loose or out of shape belt. Page 9.
• Put handle in operating position. Tilt the cleaner back to raise the
front wheels off the floor. Then turn the knob to a higher setting.
• Replace a broken, cut, loose or out of shape belt. Page 9.
• Hint: Put handle in operating position. Tilt the cleaner back to
raise the front wheels off floor. Then turn the knob. Page 6.
• Call Electrolux on 08706 055055. Have the model and serial numbers
ready when you call. See rating plate beneath the cleaner.
• Call Electrolux on 08706 055055. Have the model and serial numbers
ready when you call. See rating plate beneath the cleaner.
Solution
11