Table of Contents
Advertisement
Problem
Drying results unsatis-
factory.
Loading door does not
close.
When pressing the
& SPECIAL CARE but-
ton, the corresponding
indicator flashes sever-
al times.
Programme inactive,
o EMPTY WATER dis-
play illuminated.
Drying cycle ends
shortly after pro-
gramme starts. E END
display illuminated.
Drying cycle lasts an
unusually long time.
Note:
After around 5 hours
the drying cycle ends
automatically (see
„Drying cycle com-
plete").
20
Possible cause
Wrong programme selected.
Lint filter clogged.
Heat exchanger clogged
with lint.
Incorrect volume of laundry.
Ventilation slots in base area
covered up.
Residue on inside surface of
drum or drum ribs.
Fine strainer not in place
and/or large mesh filter not
locked in place.
Washing protection. After
the start of the programme,
the option can no longer be
set.
Condensate tank is full.
Not enough washing load-
ed or washing loaded is too
dry for selected programme.
Lint filter clogged.
Heat exchanger clogged
with lint.
& SPECIAL CARE button
pressed and load volume too
big.
Load volume too big.
Laundry insufficiently pre-
drained.
Remedy
Select a different programme
the next time you dry (see
"Overview of programmes"
section).
Clean lint filter.
Clean heat exchanger.
Observe recommended load-
ing volumes.
Uncover ventilation slots in
base area.
Clean inside surface of drum
and drum ribs.
Install fine strainer and/or
snap large mesh filter into
place.
Turn the programme knob to
O OFF. Set the programme
again.
Empty condensate tank, then
start programme with
START/PAUSE button.
Select time programme or
higher drying level (e.g.
N INTENSIVE DRY instead of
» STORAGE DRY).
Clean lint filter.
Clean heat exchanger.
& SPECIAL CARE is only suita-
ble for use with loads of up to
2,5kg!
Reduce load volume.
Laundry must be adequately
pre-drained.
Advertisement
Table of Contents
