MNP/V.42/V.42bis/V.44
42
g
m n
&T6
&T7
&T8
&V
&V0
&V1
&W_
&W0
&W1
%E_
%E0
%E1
+MS?
+MS=?
+MS=a,b,c,e,f
n
m n
%C_
%C0
%C1
%C2
%C3
&Q_
&Q0
&Q5
&Q6
+DS44=0, 0
I
Perform a Remote Digital Loopback Test
Perform a Remote Digital Loopback Test and
Self-Test
Perform Local Analog Loopback Test and Self-Test
Displays Active and Stored Profiles
Display Last Connection Statistics
Stores the active profile as Profile 0
Stores the active profile as Profile 1
Disable auto-retrain
Enable auto-retrain
Displays the current Select Modulation settings
Displays a list of supported Select Modulation
options
Select modulation where: a=0, 1, 2, 3, 9, 10,
11, 12, 56, 64, 69; b=0-1; c=300-56000;
d=300-56000; e=0-1; and f=0-1. A, b, c, d, e,
f default=12, 1, 300, 56000, 0, 0. Parameter "a"
specifies the modulation protocol desired where:
0=V.21, 1=V.22, 2=V.22bis, 3=V.23, 9=V.32,
10=V.32bis, 11=V.34, 12=V.90,K56Flex,V.34......,
56=K 56Flex, V.90,V.34......, 64=Bell 103, and
69=Bell 212. Parameter "b" specifies automode
operations where: 0=automode disabled, 1=
automode enabled with V.8/V.32 Annex A.
Parameter "c" specifies the minimum connection
data rate(300-56000). Parameter "d" specifies
the maximum connection rate(300-56000);
Parameter "e" specifies the codec type(0=Law,
and 1=A-Law). Parameter "f" specifies "robbed
bit" signaling detection(0=detection disabled
1=detection enabled)
I
Disable MNP Class 5 and V.42bis data compression
Enable MNP Class 5 data compression only
Enable V.42bis data compression only
Enable MNP Class 5 and V.42bis data compression
Direct data link only (same as \N1)
V.42 data link with fallback options
Normal data link only (same as \N0)
Disable V.44