Installation - Alpine DVI-9990 Manual For Installation And Connections

Installation

Installation Location
Before deciding on the mounting location, check that opening and closing the display will not
hamper gear shifting in that position.
• Install at an angle of within 35 degrees from the horizontal.
1
Remove the Detachable Front Panel (refer to page 9 of Owner's Manual). Remove the front
frame from main unit (see "Removal" on page 7).
Slide the mounting sleeve into the dashboard.
2
Reinforce the head unit with the metal mounting strap (not supplied). Secure the ground lead of
the unit to a clean metal spot using a screw (#) already attached to the vehicle's chassis.
NOTE
For the screw marked ##, use an appropriate screw for the chosen mounting location.
Connect each input lead coming from the product you are connecting with to the correspond-
ing output lead coming from the left rear of the DVI-9990. Connect all other leads of the DVI-
9990 according to details described in the "Connections" section.
6
-EN
Mounting Sleeve (Included)
DVI-9990
Hex Nut (M5)
Metal Mounting
Strap
Ground Lead
Dashboard
Screw
##
Bolt Stud
#
DVI-9990
Chassis