Maintenance; Ordinary Maintenance; Special Maintenance; Replacement Of Internal Lamp - Cadco UNOX OV-003 Instruction Manual

IV. MAINTENANCE

1. ORDINARY MAINTENANCE

• All maintenance operations must be done only by trained qualified personnel.
• Before starting any maintenance operation, disconnect your oven from the electrical power supply and
wait for it to cool down.
• The parts that need ordinary maintenance can be reached by removing the front control panel and the
back of the oven.

2. SPECIAL MAINTENANCE

• All maintenance operations must be done only by trained qualified personnel.
Before starting any maintenance operation, disconnect your oven from the electrical power supply and
•
wait for it to cool down.

2.1 REPLACEMENT OF INTERNAL LAMP

To replace the internal lamp:
• Disconnect your oven from the power supply system and let it cool down.
• Remove the side rails.
• Unscrew the glass cover and replace the lamp with an identical bulb.
• Screw the glass cover back on.
Reassemble the side rails.
•

2.2 RESET THE SAFETY THERMOSTAT

• This oven is equipped with a manually resettable safety thermostat designed to protect the oven against
overheating. If this occurs, it completely deactivates the oven to avoid permanent damage.
• To reset the safety thermostat, remove the black cap positioned at the bottom
of the back of the oven by unscrewing it counterclockwise, push the reset
button under the cap, and replace the black cap.
• If the safety thermostat shuts your oven off, before turning your oven back on,
be sure to check your entire circuit to verify that the total amps being drawn by
all the appliances, lights, etc. on that circuit do not exceed the amps available
on that circuit.
7