Technical Specifications - BSS Audio Soundweb London BLU-16 Installation Manual

10

Technical specifications

INPUTS
Mic/Line Inputs:
Maximum input level:
CMRR:
Equiv. Input Noise (EIN):
Phantom power:
OUTPUTS
Maximum Output Level:
Frequency Response:
THD:
Dynamic Range:
Crosstalk:
CONTROL PORTS
Control Input Voltage:
Control Input Impedance:
Logic Output Voltage:
Logic Output Impedance:
Logic Output Current
WATCHDOG OUTPUT
Opto Output current:
Withstanding voltage:
Series Impedance:
CONTROL NETWORK
Connectors:
Maximum cable length:
CobraNet AUDIO NETWORK (BLU-80, BLU-32 only)
TM
Connectors:
Maximum cable length:
Panel LED Indicators:
Mains Voltage:
Power Consumption:
Operating Temperature Range:
BSS Audio incorporates high quality mechanical fans in some products. All mechanical fans have a
limited life expectancy. We recommend annual inspection of fans for dust occlusion and excessive noise.
Fan assemblies should be replaced after six to ten years of use. Environmental factors such as elevated
temperature, dust, and smoke can adversely affect fan life. Systems exposed to these conditions should be
inspected more frequently. Fan replacement can be performed either at the factory or by an experienced
technician in the field. Please contact BSS Technical Support for more information on purchasing
replacement parts or product service.
BSS Audio has a policy of continued product improvement and accordingly reserves the right to change
features and specifications without prior notice.
Up to 16 Analogue; electronically balanced on Phoenix/Combicon removable
screw connectors.
Nominal gain 0dB, electronically switchable up to +48dB,in +6dB steps, input
impedance 3.5kOhm
+20dBu with 0dB input gain, (+8dBu with 12dB gain)
>75dB at 1kHz
<-128dBu typ with 150 Ohms source
48V nominal, selectable per input
up to 16 Analogue; electronically balanced on Phoenix/Combicon removable
screw connectors.
+19dBu
20Hz to 20kHz (+0.5/-1dB)
<0.01% (20Hz to 20kHz, +10dBu output)
108dB typ. (22Hz to 22kHz unweighted)
<-75dB
12 inputs and 6 outputs
0 to 4.5v
4.7kOhms to +5V (2-wire mode)
>1MOhm (3-wire mode)
0 or +5V unloaded
440 Ohm
10mA source, 60mA sink
Phoenix/Combicon connector for failsafe control
14mA maximum
80V maximum (Off)
220 Ohms (isolated)
RJ45 Ethernet connector (BLU-16, BLU-10), 2 x CobraNet RJ45
Ethernet connector (BLU-80, BLU-32)
100m/300ft between device and Ethernet switch
2 x RJ45 connectors
100m/300ft between device and Ethernet switch
Signal Present (per input), CLIP (per input), SYNC/48V (per input), LCD
Display,conductor active, Net Link active, Data Activity.
85-270V AC, 50/60Hz
<35VA
15 to 35 degrees C