Presetting Stations Manually; Presetting Stations Automatically; Tuning To Preset Stations; Rds - Alpine CDE-W203RI Owner's Manual

Presetting Stations Manually

1
Select the radio band and tune in a desired radio
station you wish to store in the preset memory.
2
Press and hold, for at least 2 seconds, any one of the
preset buttons (1 through 6) into which you wish
to store the station.
The selected station is stored.
The display shows the band, preset number and station
frequency memorized.
• A total of 30 stations can be stored in the preset memory (6 stations
for each band; FM1, FM2, FM3, MW and LW).
• If you store a station in a preset memory which already has a station,
the current station will be cleared and replaced with the new station.
• If the indicator is illuminated, turn off the indicator by pressing
FUNC./SETUP, and then you can perform the operation.

Presetting Stations Automatically

1
Press BAND/TA repeatedly until the desired radio
band is displayed.
2
Press and hold TUNE/A.ME for at least 2 seconds.
The frequency on the display continues to change while the
automatic memory is in progress. The tuner will
automatically seek and store 6 strong stations in the
selected band. They will be stored into preset buttons 1 to 6
in order of signal strength.
When the automatic memory has been completed, the tuner
goes to the station stored in preset location No.1.
• If no stations are stored, the tuner will return to the original station
you were listening to before the auto memory procedure began.

Tuning to Preset Stations

1
Press BAND/TA repeatedly until the desired band is
displayed.
2
Press any one of the station preset buttons
(1 through 6) that has your desired radio station in
memory.
The display shows the band, preset number and frequency
of the station selected.
• If the indicator is illuminated, turn off the indicator by pressing
FUNC./SETUP, and then you can perform the operation.

RDS

1 /AF
/ESC
BAND/TA Rotary encoder
Setting RDS Reception Mode and
Receiving RDS Stations
The RDS (Radio Data System) is a radio information system using the
57 kHz subcarrier of regular FM broadcast. The RDS allows you to
receive a variety of information such as traffic information, station
names, and to automatically re-tune to a stronger transmitter that is
broadcasting the same programme.
1
Press FUNC./SETUP so that the
lights up.
2
Press 1 /AF to activate the RDS mode.
3
Press or to tune in the desired RDS
station.
4
Press 1 /AF again to deactivate the RDS mode.
5
Press FUNC./SETUP to activate the normal mode.
The indicator goes out.
• Operate the unit while the
performed for 10 seconds, the
The RDS digital data includes the following:
PI Programme Identification
PS Programme Service Name
AF List of Alternative Frequencies
TP Traffic Programme
TA Traffic Announcement
EON Enhanced Other Networks
/ENT
VIEW
FUNC./SETUP
indicator
indicator lights up. If no operation is
indicator goes out.
9
-EN