Synchronizing The Door Windows - Mercedes-Benz ML320 Cdi Operator's Manual

Controls in detail
Power windows
Fully opening the door windows
(Express-open)
Press switch 1, 2, 3, or 4
( page 236) past the resistance point
and release.
The corresponding door window opens
completely.
Fully closing the door windows
(Express-close)
Pull switch 1, 2, 3, or 4
( page 236) past the resistance point
and release.
The corresponding door window closes
completely.
Warning!
Driver's door only:
If within 5 seconds switch is again pulled
past the resistance point and released, the
automatic reversal will not function.
238
If the upward movement of a door window
is blocked during the closing procedure,
the door window will stop and open slight-
ly.
Remove the obstruction.
Pull the respective power window
switch past the resistance point again
and release.
i
If the door window still does not close when
there is no obstruction, pull and hold the respec-
tive power window switch. The door window will
then close without the obstruction sensor
function.
Stopping door windows during
Express-operation
Press or pull respective power window
G
switch again.

Synchronizing the door windows

The door windows must be resynchronized
after the battery was disconnected
if the door windows cannot be fully
opened (Express-open) or closed
(Express-close)
i
Each door window must be resynchronized
separately.
Close all doors.
Switch on the ignition ( page 40).
Pull and hold power window switch 1,
2, 3, or 4 ( page 236).
Once a door window is closed com-
pletely, hold the respective switch for
approximately 3 seconds.
The door window is synchronized.