Canon PowerShot A200 Software Starter Manual page 82

78
If the "ImageBrowser Not Found" Dialog Appears
This dialog may display if you install the Plug-In Module without installing
ImageBrowser, and then connect via the USB interface. Use the following procedures
to change the auto start setting for ImageBrowser.
1. Click [OK] on the ImageBrowser Not Found dialog.
2. In the Settings for USB Connection dialog, click the [The application program
below will start.] option to clear the check mark.
3. Close the Settings for USB Connection dialog.
This will prevent the ImageBrowser Not Found dialog from appearing the next time
the camera is connected.
• You can also open the Settings for USB Connection dialog by clicking the Apple
menu
CF Card Reader / PC Card Reader Connection
1.
Insert the CF card or loaded PC card adapter into the reader.
2.
Start Adobe Photoshop.
and selecting [Control Panels] and [Canon ImageBrowser Auto Launch].
Click here to clear the check mark.
Click here to close the dialog.