Diagnostic error codes
Refer to the following diagnostic error codes when using the diagnostic tests. See "Running tests" on page
37 for the specific type for information about the Diagnostic programs.
In the following index, X can represent any number.
Diagnostic Error Code
000-000-XXX BIOS Test Passed
000-002-XXX BIOS Timeout
000-024-XXX BIOS Addressing test failure
000-025-XXX BIOS Checksum Value error
000-026-XXX FLASH data error
000-027-XXX BIOS Configuration/Setup error
000-034-XXX BIOS Buffer Allocation failure
000-035-XXX BIOS Reset Condition detected
000-036-XXX BIOS Register error
000-038-XXX BIOS Extension failure
000-039-XXX BIOS DMI data error
000-195-XXX BIOS Test aborted by user
000-196-XXX BIOS test halt, error threshold exceeded
46
ThinkCentre Hardware Maintenance Manual
FRU/Action
No action
1. Flash the system. See "Updating (flashing) BIOS
from a CD-ROM or diskette" on page 775
2. System board
1. Flash the system. See "Updating (flashing) BIOS
from a CD-ROM or diskette" on page 775
2. System board
1. Flash the system. See "Updating (flashing) BIOS
from a CD-ROM or diskette" on page 775
2. System board
1. Flash the system. See "Updating (flashing) BIOS
from a CD-ROM or diskette" on page 775
2. System board
1. Run Setup
2. Flash the system. See "Updating (flashing) BIOS from
a CD-ROM or diskette" on page 775
3. System board
1. Reboot the system
2. Flash the system. See "Updating (flashing) BIOS from
a CD-ROM or diskette" on page 775
3. Run memory test
4. System board
1. Flash the system. See "Updating (flashing) BIOS
from a CD-ROM or diskette" on page 775
2. System board
1. Flash the system. See "Updating (flashing) BIOS
from a CD-ROM or diskette" on page 775
2. System board
1. Flash the system. See "Updating (flashing) BIOS
from a CD-ROM or diskette" on page 775
2. Adapter card
3. System board
1. Flash the system. See "Updating (flashing) BIOS
from a CD-ROM or diskette" on page 775
2. System board
Information only Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file