Replacing The Hard Disk Drive - Lenovo IdeaCentre K330B Hardware Replacement Manual

Replacing the hard disk drive

Attention:
Do not remove the computer cover or attempt any repair before reading the
"Important safety information" in the Safety and Warranty Guide that was
included with your computer or in the Hardware Maintenance Manual (HMM)
for the computer. To obtain copies of the Safety and Warranty Guide or
HMM, go to the Support Web site at http://consumersupport.lenovo.com.
To replace the hard disk drive:
1. Remove the computer cover. Refer to "Removing the computer cover".
Note: For this procedure, it helps to lay the computer on its side.
2. Disconnect the data and power cables from the hard disk drive.
3. Use the plastic handle to slide the hard disk drive out of the drive bay.
4. Slide the new hard disk drive into the drive bay.
5. Twist the drive bay into place.
6. Connect the power and signal cables to the hard disk drive. Refer to "Identifying
parts on the system board".
Hardware Replacement Guide
19