Brady BRADYMARKER XC Plus Manual page 10

BRADYMARKER
3. With screwdriver, turn the plastic "gap adjustment screw" (turn clockwise only!) To the
desired setting. The smallest gap (locator dots at 12 o'clock) is used for all non-
PermaSleeve consumables. The next smallest gap (4 o'clock) is the standard setting for
PermaSleeve markers. The final position (7 o'clock) should only be used if the printer
smears with the 4 o'clock setting.
4. With screwdriver, re-tighten adjuster lock screw. Be careful not to over-tighten screw!
5. Replace printer cover.
When adjusting the print head gap, be careful not to move the optic scanner within its plastic
holder. The scanner position is critical to proper machine operation. If scanner is accidentally
moved, refer to (Section F, pg. 10) for instructions on resetting the scanner gap.
C. Setting the unit for sleeve size
Follow the instruc tions on page 11 in the tutorial section "Press the MENU key...". Like other
Bradymarker labels, PermaSleeve markers have the marker size code shown on the package
and on the inside of the roll core.
After entering the marker size code and the appropriate format option, you will be asked the
question.
Printing PSBX sleeves?
Press Y or N.
Select Y in using PermaSleeve markers; select N in all other cases. This will set the proper
margin for the printer. This is necessary due to PermaSleeve marker's different location (left-
to-right) on its carrier than other Bradymarker labels.
D. Loading PermaSleeve wire marker sleeves
Before attempting to load PermaSleeve markers, make sure that unwind assembly and proper
printer cover are in place, material guide is set to widest position, and correct marker size
information had been entered. Load PermaSleeve markers as follows (refer to Fig. B).
1. Make sure power in ON.
2. With the leading end approximately on top of the roll, set the roll of sleeves into the
unwind assembly so that they will unwind in the direction shown in Fig. B on the next
page.
3. Turn the roll "backwards" (opposite the arrow in Fig. B) until the leading edge "pops"
under the front roller in the unwind assembly.
PS printer
Page 10