QSC DCP 100 User Manual page 17

6. Follow the on-screen prompts/instructions
7. Repeat steps 1 through 6 to install QSControl.net™
USB Driver Warning
DCP Manager must be installed on your PC or laptop prior to connecting it to the DCP product. This ensures that the USB driver is properly installed
on your PC or laptop prior to establishing a connection to the DCP product via the computer's USB port.
Configuring the DCP
DCP Manager™ is used to configure the DCP product. This includes configuring the device properties, the DSP objects, audio and control I/O and
Presets. The network communications properties and audio networking features can also be configured using DCP Manager™ so that all networking
properties are in place before the DCP is added to a local area network (if your deployment requires networking). Alternately the DCP is accessible via
SNMP remote management.
Once the DCP product is configured via DCP Manager™, the QSControl.net™ suite of applications (Venue Manager, QSCreator™, Notify and the
QSControl™ 3 Party API) can then be used to manage one or more DCP products over a local area network.
rd
Refer to the information in the DCP Manager™ and QSControl.net™ application Help Files for additional information on product configuration,
management and network connectivity.
Connections
AC Power Cord
Insert the molded receptacle of the AC power cord into the AC power inlet on the back of the DCP
product. Plug the AC line connector into an AC outlet. The power supply on the DCP product will
accept from 100 to 240V, 50 to 60 Hz. If a different type of IEC power cord is required than that
supplied with the product, consult QSC's Technical Services Group.
QSControl™ Network
Connect one end of a data communications cable terminated with an RJ45 plug into the QSControl™
receptacle on the rear panel of the DCP product. Ensure that the lock tab on the cable engages with
the RJ45 receptacle on the DCP rear panel connector. Note: data communications cabling must
be rated CAT-3 or better for 10 Mbps network connections or rated CAT-5 or better for 100 Mbps
network connections.
CobraNet Network
(DCP 200 and DCP 300 models only)
Connect one end of a data communications cable terminated with an RJ45 plug into the CobraNet™
Primary receptacle on the rear panel of the DCP product. Ensure that the lock tab on the cable
engages with the RJ45 receptacle on the rear panel DCP connector. For systems requiring redundant
network connections, connect a second data communications cable terminated with an RJ45
plug into the CobraNet™ Secondary receptacle on the rear panel of the DCP product. Note: data
communications cabling must be rated CAT-5 or better for all CobraNet™ connections.
16