A D J U S T I N G T H E I F / B L E N D - Primare T21 User Manual

Advanced use
>
• Press the DISPLAY button.
The first position on the 16-digit display will flash.
• Use the UP and DOWN buttons to select the first character and press the
DISPLAY button to store it.
The cursor will move forward to the next position on the display.
• Use the UP and DOWN buttons to select the next character, and press the
DISPLAY button again to store it.
Continue until the station name is complete.
• Press the STORE button to store the completed name.
There are 69 characters available to use in the sequence: 0–9, punctuation,
A–Z, and a–z.
If a manually entered name is stored to an RDS station, the transmitted RDS
name will not be displayed. If you want to show the RDS name again, you will
have to delete the manually entered name first, as follows.
To delete a stored name
• Press the STORE button.
The display will change so that the preset number is flashing eg "P14".
• Press the DISPLAY button.
• Press the STORE button again to delete the name.
8

A D J U S T I N G T H E I F / B L E N D

The Primare T21 Tuner allows you to adjust the Intermediate Frequency (IF)
control and the Blend mode of the tuner.
Adjusting the IF mode enables you to choose between two IF settings: WIDE
and NARROW. For the best possible quality sound with strong signals select
IF WIDE. To remove interference between stations that are very close to each
other in frequency select IF NARROW.
Adjusting the BLEND mode enables you to choose between two BLEND
settings: ON and OFF. You can reduce noise and hiss on remote or weak
stations by choosing BLEND ON. However, this will be at the expense of
reduced stereo separation, so for strong signals choose BLEND OFF.
To adjust the Intermediate Frequency
• Press the SELECT button on the front panel.
The display will show the current IF status; for example:
I F N A R R O W
• Press the UP or DOWN buttons to change between IF WIDE and IF
NARROW.