Wlan Internet Access Points - Nokia N78 User Manual

Password — A password may be needed to make
●
a data connection and is usually provided by the
service provider.
Authentication
●
your password encrypted or
password encrypted when possible.
Homepage — Depending on the access point you
●
are setting up, enter the web address or the address
of the multimedia messaging centre.
Select Options
>
following settings:
Network type
●
to transfer data to and from your device. The other
settings depend on the selected network type.
Phone IP address
●
address of your device.
DNS addresses
●
primary and secondary DNS servers, if required by
your service provider. Contact your internet service
provider to obtain these addresses.
Proxy server address
●
proxy server.
Proxy port number
●
the proxy server.

WLAN internet access points

Press , and select
Connection Destinations
>
154
and follow the instructions on the screen. Or, open one
— Select Secure to always send
Normal to send your
Advanced settings to change the
— Select the internet protocol type
(for IPV4 only) — Enter the IP
— Enter the IP addresses of the
— Enter the address of the
— Enter the port number of
Tools Settings
> >
New access
>
of the access point groups, select an access point
marked with
Follow the instructions from your WLAN service
provider.
WLAN network name
●
Search for
network, WLAN network mode
security mode
access point device.
Network status
●
name is displayed.
WLAN network mode
●
an ad hoc network and to allow devices to send and
receive data directly; a WLAN access point device is
not needed. In an ad hoc network, all devices must
use the same
WLAN security mode
●
used: WEP,
WPA/WPA2. If you select
encryption is used. The WEP, 802.1x, and WPA
functions can be used only if the network supports
them.
To enter the settings for the selected security mode,
select WLAN security
Security settings for WEP
WEP key in use
●
privacy (WEP) key number. You can create up to four
point,
, and select Edit.
— Select Enter manually
networks. If you select an existing
and
are determined by the settings of its
— Define whether the network
— Select Ad-hoc
WLAN network name.
— Select the encryption
802.1x (not for ad hoc networks), or
Open network, no
config..
— Select the wired equivalent
or
WLAN
to create