P R I N T W H E E - Nakajima AE-710 Operation Manual

Printwheel
Removing printwheel
l) Open the top cover and remove the ribbon cassette as explained
u n d e r " R e m o v i n g r i b b o n c a s s e t t e " .
2) Pull the printwheel set/release lever toward you. The whole print
head shifts toward you and the printwheel is released.
3) Lightly grasp the top of the printwheel and carefully pull it up.
Note:
Be careful not to bend the top of the ribbon guides.
lnstalling printwheel
l ) Lightly grasp the edge of the printwheel. Carefully lower it in
between the print head and the ribbon guides,
Note:
Make sure that the typeface side faces the ribbon guides.
2) Push the printwheel set/release lever. The whole print head shifts
back and the printwheel snaps into place.
Press the lever again as far as it goes to make sure the printwheel
is locked into place.
3) Reposition the ribbon cassette and close the top cover.
Note:
Reposition the printwheel if there are any abnormal sounds or if
incorrect characters are printed.
ribbon guide
28