Troubleshooting - Black Widow Security BW FM 6150 Installation Manual

Problem
Alarm does not operate.
Alarm will not Passively Arm.
Alarm will not enter Code
Learning Mode.
Alarm chirps 4 times 5 sec-
onds after system is Armed.
Parking lights do not flash.
Door locks do not lock or
unlock correctly, or action is
reversed
Illuminated Entry does not
activate on upon disarm.

TROUBLESHOOTING

Probable Cause
Alarm in Valet Mode; Ignition
input has voltage on it; Missing
+12V or ground.
Unit is not programmed for
Passive Arming,wrong polarity
door input wire, Yellow igni-
tion input has 12V+ on it.
Ignition was not left in the on
position after turning it on &
off three times; Sequence not
performed rapidly enough (5
sec.);Valet/Override Switch is
defective or not plugged in.
Factory Dome light Delay is
longer than 5 seconds; Door
open or defective pin switch;
Shock sensor is not properly
adjusted or defective.
Wrong wire connected,
Wrong polarity selected, or
RED Wire #1 not connected
to battery power.
Defective GREEN or BLUE
wire in door lock connector
plug, GREEN and BLUE wires
reversed, or wrong door lock
wiring diagram used.
External relay required, or
Wrong polarity wired for
relay.
12
Suggested Correction
Take alarm out of Valet mode;
Turn key off and verify yellow
wire is connected to correct
ignition wire; Check +12V and
ground connections.
Program step #1 for Passive
Arming; Correct door switch
polarity; Change ignition input
wire; Make sure alarm is not in
Valet.
Leave ignition in on position;
Repeat procedure quicker;
Replace valet switch.
If dome light delay is longer
than 5 seconds program Step
#10 to OFF; Replace defective
pin switch; Adjust or replace
shock sensor.
Connect WHITE wire to
proper wire, Reverse jumper
polarity (see Jumper Settings),
Connect RED wire #1 to +12V.
Check GREEN and BLUE wires
on door lock connector plug;
Verify vehicle's type of door
lock system; Reverse wiring to
door relays.
Add relay (see Relay Wiring
Diagrams; Reverse relay polar-
ity.