Table of Contents
Advertisement
PASSIVE ARMING
The passive arming feature allows the system
to automatically arm after closing all doors.
The Passive Arming feature requires the
ignition to have been on for at least 10
seconds prior to exiting the vehicle. This
enables the key to be turned on then off
quickly to avoid passive arming in the event
of refueling, washing the vehicle, etc. The
Passive Arming feature may be enabled during
installation.
To arm the system passively:
1. Turn the ignition key off (make sure
ignition was on for at least 10 seconds).
2. Exit the vehicle and close all doors.
• The LED flashes rapidly indicating that
the system is preparing to arm. (The
system can be armed at any time by
pressing transmitter button 1.)
• If the optional countdown feature is
programmed, the siren will chirp
every 2 seconds until armed.
• The siren will chirp 30 seconds after
the last door is closed to indicate the
system is armed. NOTE: Opening the
hood/trunk or a door resets the
passive arming timer.
• The doors will lock.†*
†
If Passive Locking was enabled during installation.
DISARMING OPERATION
To disarm the system press transmitter
button 2.
• The siren will chirp twice.
• The parking lights will flash twice.*
• The doors will unlock.†*
• The dome light will turn on for 30
seconds.*
†
If the Passenger Unlock Feature is installed,
pressing the unlock button will unlock only the
driver's door. Pressing the unlock button again
unlocks all doors.
TAMPER ALERT
If the alarm was triggered while away from
the vehicle, the siren will chirp 3 times and
the parking lights will flash 3 times on
disarming for tamper indication. After
disarming the alarm, enter vehicle and turn
ignition on.The LED will flash the zone that
was triggered 3 times (see LED TAMPER
ALERT INDICATIONS).
AUTO REARM
The Auto Rearm feature allows the system
to automatically re-arm itself and lock the
doors* in the event the system is disarmed
and a door is not opened within 30
seconds. This programmable feature may
be enabled during installation.
SILENT ARMING/DISARMING
Press transmitter button 5 (the Shift
Button) then the Arm or Disarm button for
one-time silent operation.The system can
also be programmed for full-time silent
operation during installation.
IGNITION LOCK*
The ignition locking feature automatically
locks the doors 5 seconds after the ignition
key is turned on, and automatically unlocks
when the ignition key is turned off. To avoid
locking keys in the vehicle, the ignition
locking feature will be cancelled if a door is
open when the ignition is turned on. This
feature may be disabled during installation.
*
Optional feature
REMOTE PANIC
In the event of an emergency (PANIC)
situation, the system's siren can be triggered
for 30 seconds to attract attention.To activate
the Panic Feature, press transmitter button 1
for 3 seconds:
2
Advertisement
Table of Contents
